Matsonic MS7112c with 933 Mhz P3??

[pikomil]

Could somebody give me information if Pentium III 933 Mhz (FCPGA) processor would work normaly on Matsonic MS7112c mainboard?

I've been already checking in mainboard manual, where it says that supporst PIII processors up to 850 Mhz. Curently i'm running on that board Celeron 700 Mhz. Oh, both are Socket 370 processors.

Thanks for all information and answers.

[Marcin]

Some years ago I had this mobo Really bad - not stabile mobo. I think this mobo will not work with PIII 933. It doesn't support FSB 133. PIII 850 is supported on 100 MHz bus and I think 8.5 is max multiplier.

[bacterio]

Update the BIOS and try it. Maybe it will go or not

[pikomil]

Thank you very much. I saw a good offer for P 3 processor, but as I said I wasn't sure if this combination would work.

[skold]

even if the board says it doesnt support a particular speed grade, it'll most likely work as long as it supports that processor.. ie, if it supports any fcpga P3s, they should all work..

[pikomil]

Well, I'am of same thoughts about this combination, but it ist understood, that I would not like to waste money on something, that in the end I could not use. Thank you skold.