| View previous topic :: View next topic |
| Author |
Message |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
Posted: Sat Jun 30, 2018 1:38 am Post subject: CPU Shack: 286-486 Motherboards - SOLD |
|
|
I REALLY dont want to collect motherboard but I ended up with a bunch of them
Board 1: - SOLD: kixs
This is a 386/486 Board with a 387 Socket embedded in the middle of the 486 socket. Comes with a TI TX486DLC/E-40GA
8x 30 Pin SIMMS
2x 8-bit ISA
4x 16-bit ISA
2x VLB
OPTi 82C495SLC Chipset
AMI 386DX ISA BIOS
$30
Board 2: - SOLD: Debs
This is a 486SX Board with a KU80486SX-25 SX673 soldered on, but with a socket for a 487 (or maybe 486DX?)
I think its a 48PX/PM-SX (thats what the stickers say)
8x 30 Pin SIMMS
2x 8-bit ISA
6x 16-bit ISA
OPTi 82C495C/82C392 + CHIPS P82C206
AMI 486DX ISA BIOS
$10
Board 3: - SOLD: Debs
This is a PLCC68 286 Board with a Intel N80286-12 CPU and FPU Socket
3x 8-bit ISA
5x 16-bit ISA
CHIIPS P82A203/4 Chipset
AMI 286 BIOS PLUS
$15
Board 4: SOLD: Debs
This is one of the transitional 386/486 board with sockets for both types of CPUs EDIT: Actually a Weitek 4167 socket
THere is a resistor network you move to select 486SX 487SX or 486
It has a 40MHz Crystal installed so is setup for 20MHz CPUs
8x 30 Pin SIMMS
2x 8-bit ISA
6x 16-bit ISA
OPTi 82C495C/82C392 + CHIPS P82C206
AMI 486 BIOS (sticker says 486SX-20 060691 BELL)
$20
Board 5: SOLD: stamasd
ANother 386/486 Board. Currently has a 25MHz crystal, and a socket for a second one next to it, maybe for the 386 socket?
EDIT: Actually a Weitek 4167 socket
8x 30 Pin SIMMS
1x 8-bit ISA
7x 16-bit ISA
SiS85C401/2 + SiS85C206 Chipset
AMI 486SX BIOS
$15
Board 6: SOLD: tray
CLassic 486 Board, socket appears to support overdrives (extra row of pins)
Comes with a Intel A80486DX-33 SX419
8x 30 Pin SIMMS
1x 8-bit ISA
4x 16-bit ISA
2x VLB
OPTi 82C495SX Chipset
AMI 486DX ISA BIOS
$15
Board 7: SOLD: sunaiac
This is a MSI MS4131 VER: 2.3 486 board I like how the added a Socket 3 ZIF and just had it hangng over the edge of the board.
It also has solderpads for a Cyrix Cx87DLC and a PQFP486. It has jumpers for 128K and 256K of Cache as well as jumpers for 1X/2X 486/487/SX, and one to enable the PSFP pads. ALso seems to support 25 33 40 and 50MHz bus
http://stason.org/TULARC/pc/motherboards/A/ACHME-COMPUTER-INC-486-MS-4131-VLB-486-AL2.html
4x 30 Pin SIMMS
2x 72-pin SIMMS (one occupied)
4x 16-bit ISA
3x VLB (one MASTER/SLAVE combo)
ALi M1429 A1 Chipset
AMI 486DX ISA BIOS
$35 _________________ New for 2025! The CPU Shack has a co-processor!
Visit The CPU Shack of microprocessor history and information.
Last edited by CPUShack on Sat Jun 30, 2018 1:03 pm; edited 6 times in total |
|
| Back to top |
|
 |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
|
| Back to top |
|
 |
debs3759

Joined: 18 Jan 2006 Posts: 9477 Location: Northampton, Divided Kingdom
|
Posted: Sat Jun 30, 2018 1:54 am Post subject: |
|
|
Board 3: _________________ My graphics card database can be found at http://www.gpuzoo.com.
I can resist anything except temptation.
Debs |
|
| Back to top |
|
 |
debs3759

Joined: 18 Jan 2006 Posts: 9477 Location: Northampton, Divided Kingdom
|
Posted: Sat Jun 30, 2018 2:30 am Post subject: |
|
|
haha, you put me down for board 2:, I asked for board 3:. I will take both though, I need a board for early 5V CPUs  _________________ My graphics card database can be found at http://www.gpuzoo.com.
I can resist anything except temptation.
Debs |
|
| Back to top |
|
 |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
|
| Back to top |
|
 |
kixs
Joined: 13 Aug 2015 Posts: 218 Location: EU, SI
|
Posted: Sat Jun 30, 2018 2:47 am Post subject: |
|
|
#1 for me, please  |
|
| Back to top |
|
 |
stamasd
Joined: 05 Jun 2014 Posts: 1311 Location: Connecticut
|
Posted: Sat Jun 30, 2018 5:42 am Post subject: |
|
|
Board 5 for me please. I have lots of motherboards but not a 386/486 one. Are these known working?
Edit: after visually scanning all the socket 2/3 motherboards at TH99 I think this one is a Silicon Star International AT4 http://arvutimuuseum.ee/th99/m/A-B/33565.htm
And as stated below, the extra socket is for a Weitek NPU, not 386. I think the only true 386/486 board in this lot was #1. I'll still take #5, boards with Weitek sockets are pretty rare too.
Last edited by stamasd on Sat Jun 30, 2018 6:19 am; edited 3 times in total |
|
| Back to top |
|
 |
Chook

Joined: 29 Oct 2008 Posts: 2250 Location: Australia
|
Posted: Sat Jun 30, 2018 5:49 am Post subject: |
|
|
The second socket on boards 4 and 5 would be for a Weitek 4167. _________________ General failure reading disk in drive A
Who's General Failure and why is he reading my disk? |
|
| Back to top |
|
 |
sunaiac

Joined: 13 Jul 2012 Posts: 312 Location: Palaiseau, France
|
Posted: Sat Jun 30, 2018 7:49 am Post subject: |
|
|
Board 7 _________________ X470 Taichi - R9 3900X - RX5700XT - 32GB |
|
| Back to top |
|
 |
tray
Joined: 01 May 2016 Posts: 137 Location: Canada
|
Posted: Sat Jun 30, 2018 10:47 am Post subject: |
|
|
| I will take #6 |
|
| Back to top |
|
 |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
Posted: Sat Jun 30, 2018 12:39 pm Post subject: |
|
|
| Chook wrote: | | The second socket on boards 4 and 5 would be for a Weitek 4167. |
woops, you are correct.
This is why I dont collect mobos haha _________________ New for 2025! The CPU Shack has a co-processor!
Visit The CPU Shack of microprocessor history and information. |
|
| Back to top |
|
 |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
|
| Back to top |
|
 |
debs3759

Joined: 18 Jan 2006 Posts: 9477 Location: Northampton, Divided Kingdom
|
Posted: Sat Jun 30, 2018 12:46 pm Post subject: |
|
|
As all the cache chips are missing, will you take $15 for #4 ? _________________ My graphics card database can be found at http://www.gpuzoo.com.
I can resist anything except temptation.
Debs |
|
| Back to top |
|
 |
CPUShack

Joined: 16 Jun 2003 Posts: 34259 Location: State of Jefferson, USA
|
|
| Back to top |
|
 |
|